Table of Contents
Advertisement
5.4 Starting A Cycle (
To start a program, press the Start/Pause
touchpad. The corresponding pilot light
will stop flashing and a default program
duration will be displayed on the screen.
After approx. 15 minutes from the start of
a program:
The appliance will automatically adjust
-
the selected program duration
according to the type and size of the
load.
-
The display will show adjusted
program duration.
NOTE
If you press any touchpad while a
program is operating, the symbol "
will flash on display along with buzzer
sound.
5.5 Interruption Of A Program
-
To pause, press Start/ Pause.
The indicator will start flashing.
-
Press the Start/Pause again.
The program will continue.
5.6 Changing A Program
Changing a running program is possible
only by resetting it.
-
Turn the program selector knob to the
position "Off" to cancel the program
and to turn off the appliance.
-
Turn the program selector knob to the
new program position and change any
available options. Press Start/Pause
to start the new program.
NOTE
The appliance will not drain the water
(except programs; Spin, Rinse + Spin,
Tub Clean).
)
5.7 Changing The Options
It may be possible to change some of the
options after a wash program has started.
Press the touchpad Start/Pause. The
1.
indicator will start flashing.
If available change the options that
2.
you wish.
Press Start/Pause again. The program
3.
will continue.
5.8 Opening The Door
While a program or the Delay End is
operating, the appliance door is locked
and the display shows the indicator "
First, set the machine to PAUSE by
"
pressing the "Start/Pause" touchpad. Wait
until the door lock indicator goes off, then
the door can be opened.
If the door lock indicator "
disappear, this means that the machine
is already heating and the water level is
above the bottom edge of the door or the
drum is turning. In this case the door
CAN NOT be opened. If you need to
open it, you must drain the water to open
the door.
5.9 At The End Of The Program
-
The appliance stops automatically.
-
The acoustic signal will operate.
-
The display will show "
-
The indicator of the touchpad
Start/Pause goes off.
-
The door lock indicator "
-
Remove the laundry from the
appliance. Make sure that the drum is
empty.
-
Keep the door partly open, to prevent
the mildew and odours.
-
Turn off the water tap.
19
".
" does not
".
" goes off.
Advertisement
Table of Contents
