Cautions And Warnings; Register Your Product - Fortinet FortiGate-40C-LENC Quick Start Manual

Table of Contents

Advertisement

8. Cautions and Warnings

Please review the following cautions and warnings.
Environmental specifications
Operating temperature: 32 to 104°F (0 to 40°C)
If you install your Fortinet product in a closed or multi-unit rack assembly, the operating ambient temperature of the
rack environment may be greater than room ambient temperature. Therefore, make sure to install the equipment in an
environment compatible with the manufacturer's maximum rated ambient temperature.
Storage temperature: -13 to 158°F (-25 to 70°C)
Humidity: 20 to 90% non-condensing
Air flow - For rack installation, make sure that the amount of air flow required for safe operation of the equipment is not
compromised.
For free-standing installation, make sure that the appliance has at least 1.5 in. (3.75 cm) of clearance on each side to allow
for adequate air flow and cooling.
FCC Compliance
Your Fortinet product complies with either FCC Class A or FCC Class B rules.
The Fortinet product has been tested and found to comply with part FCC Class A, Part 15, UL/CUL, C Tick, CE and VCCI.
Operation is subject to the following two conditions:
This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired operation.
The Fortinet product has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
The equipment complies with FCC radiation exposure limits set forth for uncontrolled environments.
Caution:
Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to your local
regulations.
Grounding
Ensure your Fortinet product is connected and properly grounded to a lightning and surge protector. WAN or LAN
connections that enter the premises from outside the building should be connected to an Ethernet CAT5 (10/100 Mb/s) surge
protector.
Shielded Twisted Pair (STP) Ethernet cables should be used whenever possible rather than Unshielded Twisted Pair (UTP).
Do not connect or disconnect cables during lightning activity to avoid damage to your Fortinet product or personal injury.
Electrostatic discharge (ESD) can damage Fortinet equipment. Only perform the procedures described in this document
from an ESD workstation. If no such station is available, you can provide some ESD protection by wearing an anti-static
wrist strap and attaching it to an available ESD connector or other bare metal object.
Bureau of Standards Metrology and Inspection (BSMI) – Taiwan
這是甲類的資訊產品,在居住的環境中使用時,可能會造成射頻干擾,在這種情況下,使用者會被要求採取某些適當的對
策。
The presence conditions of the restricted substance (BSMI RoHS table) are available at the link below:
https://www.fortinet.com/bsmi

9. Register Your Product

If you did not register your Fortinet product using the FortiExplorer wizard,
please register your product now.
Register
Register your Fortinet product in order to receive:
• Technical Support • New product features • Protection from new threats
Enregistrer
Vous devez enregistrer le produit pour recevoir:
• Support technique • Nouvelles fonctionnalitées du produit • Protection contre
de nouvelles menaces
Registra
La reistrazione ti permette di usufruire di:
• Supporto Tecnico • Nuove funzionalita • Proteezione dalle ultime minaccce
Registrar
Debe registrar el producto para recibir:
• Apoyo técnico • Nuevas funcionalidades del producto • Protección contra
ataques
登録のお願い
本日、 フォーティネッ ト製品の登録をしてください。
登録すると次のメリッ トがあります。
テクニカルサポート • 新機能の追加 • 新しい脅威への防御
请马上注册
您的飞塔产品
您在注册以后才能得到技术支持、新产品特点信息、最新威胁防护
Web: https://support.fortinet.com/
Toll free: 1 866 648 4638
Phone: 1 408 486 7899
Fax: 1 408 235 7737
Email: register@fortinet.com

Advertisement

Table of Contents
loading

Table of Contents