ECS L4IBME 1.0 Manual page 23

Follow these instructions to install an add-on card:
1. Remove a blanking plate from the system case corresponding to the slot you
are going to use.
2. Install the edge connector of the
add-on card into the expansion
slot. Ensure that the edge con-
nector is correctly seated in the
slot.
3. Secure the metal bracket of the card to the system case with a screw.
Note: For some add-on cards, for example graphics adapters and network adapters,
you have to install drivers and software before you can begin using the add-on
card.
How to use the AGP slot:
To lock the graphics card into place,
simply insert the AGP card into the
AGP slot as you normally would and
then slide the lock to the left.
Note: Don't force the card. If
you meet a lot of resi s tance, pull
the card out. Check the connec-
tor and the slot for damage or
obstruction, and then try inserting
the card again.
19