Audiovox CDA1361 Operating Instruction

CARE & MAINTENANCE
GENERAL GUIDELINES
• Do not touch the laser lens on the CD player.
• Temperature changes can cause condensation to form on the laser
lens. If condensation forms on the lens, leave the disc compartment
door open (without disc) for an hour to remove condensation.
• Exposure to direct sunlight or extreme heat (such as inside a car
parked in the sun) can cause damage or malfunction.
• To prevent dust from reaching internal parts, keep the compartment
door closed when not using (except when necessary to remove
condensation).
HANDLING THE COMPACT DISC
It's important that you periodically clean the laser
lens:
1. Turn off the unit's power and disconnect the AC
power.
2. Open the CD door and remove the disc.
3. Clean the lens with a soft cloth or use an air
blower brush designed for cameras.
4. If you still are not able to remove dirt particles,
moisten a cotton swab with isopropyl alcohol
and gently apply to the face of the laser lens,
rubbing gently until all traces of dirt are removed.
Although the music tracks in the disc are covered
with a protective layer, it is still advisable to treat
the disc carefully. Always pick up discs by the edge
and put them back in their holders immediately after
use.
CLEANING THE UNIT
Do not use volatile chemicals on this unit. Clean by lightly wiping with
a soft cloth.
IMPORTANT NOTICES:
• Should the CD door be opened before the reading of the CD is
completed, a jamming noise may occur. This can be resolved by
closing the CD door and then sliding the FUNCTION switch
temporarily to OFF.
• If an abnormal display indication or an operating problem occurs,
disconnect the AC power cord and remove the batteries. Wait at
least 5 seconds, then reconnect the AC power cord or reinstall the
batteries.
TROUBLE SHOOTING TIPS
CD
Solutions
Problems
• Make sure AC power plug is secure in
System does not turn on
Disc in place but unit
• Batteries may be dead. Install new
won't play
• Make sure the FUNCTION switch is set
• Make sure disc is clean and undamaged.
• Make sure printed side of disc is facing
• Make sure PAUSE mode is not activated.
• Make sure the unit is on a secure spot.
RADIO
Problems
Solutions
Poor FM reception
• Electrical interference in your home
Poor AM(MW) reception
• Reposition or turn the unit for better
the outlet and inlet has power.
batteries.
to CD position.
up.
Vibration or jarring can cause the disc
to skip.
can cause poor reception. Move the
unit away from them (especially those
with motors and transformers).
reception.
PORTABLE CD SYSTEM
OPERATING INSTRUCTION
Laser lens
The lightning flash
and
within the triangle is
a warning
alerting
"dangerous voltage"
inside the product.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR MOISTURE.
CLASS 1 LASER PRODUCT
CLASS 1 LASER
PRODUCT
This product contains a low power laser device.
SAFETY PRECAUTIONS
Follow the advice below for safe and appropriate operations.
ON PLACEMENT
• Do not use the unit in places which are extremely hot, cold, dusty or
humid.
• Place the unit on a flat and even surface.
• Do not restrict the air flow of the unit by placing it in a place with
poor air flow, by covering it with a cloth, or by placing it on a carpet.
ON SAFETY
• When connecting and disconnecting the AC cord, grip the plug and
not the cord itself. Pulling the cord may damage it and create a
hazard.
• When you are not going to use the unit for a long period of time,
disconnect the AC power cord.
ON AC VOLTAGE
• Before use, check that the rated voltage of your unit matches your
local voltage.
• When there is condensation inside the unit, the unit may not function
normally.
• Let it stand for 1 to 2 hours before turning the power on, or gradually
heat the room up and dry the unit before use.
FCC INFORMATION (for USA)
This device complies with part 15 of FCC Rules. Operations are subject
to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesirable operations.
Should any trouble occur, disconnect the AC power cord and refer
servicing to qualified personnel.
RATING PLATE LOCATION
The rating plate location is on the bottom of product.
811-136191-011
WARNING: TO REDUCE THE
arrowhead RISK OF ELECTRIC SHOCK, DO
NOT REMOVE COVER (OR
sign BACK) NO USER-SERVICEABLE
you of PARTS INSIDE.
SERVICING TO QUALIFIED
SERVICE PERSONNEL.
CAUTION
INVISIBLE LASER RADIATION WHEN
OPEN AND INTERLOCKS DEFEATED.
AVOID EXPOSURE TO BEAM
The exclamation
point within the
triangle is a warning
sign alerting you of
REFER
important instructions
accompanying the
product.
Printed in China