Advertisement
IMPORTANT INSTALLATION GUIDELINES
Proper Log Placement
Log placement is critical to proper burner performance. Logs must
be correctly positioned. The photos in this manual show the proper
pinned position for logs on this set. Owners need to be shown proper
log placement and instructed not to move the logs.
Logs must fit firmly onto the burner when positioned as shown in
the photos. Misformed logs or logs with sloppy pin holes must be
replaced.
Proper Placement of Glowing Embers
Glowing embers can be added to burners for a glowing ember effect.
It must be positioned only on top of the burner. The photos in this
manual show the proper placement of glowing embers.
Make Owners Aware of Proper Log Set Operation
Properly installed and properly maintained log sets do not deposit
soot on the logs. If users see soot appear on a log, call for service.
Do not continue to operate the log set.
Qualified Installing Agency
f i r e - p a r t s . c o m
Installation and replacement of gas piping, gas utilization
equipment or accessories and repair and servicing of equip-
ment shall be performed only by a qualified agency. The term
"qualified agency" means any individual, firm, corporation,
or company that either in person or through a representa-
tive is engaged in and is responsible for (a) the installation,
testing, or replacement of gas piping or (b) the connection,
installation, testing, repair, or servicing of equipment; that is
experienced in such work; that is familiar with all precautions
required, and that has complied with all the requirements of
the authority having jurisdiction.
The installation must conform with local codes or, in the
absence of local codes, with the National Fuel Gas Code,
ANSI Z223.1/NFPA54.*
*Available from the American National Standards Institute, Inc. 11 West
42nd St., New York, N.Y. 10018.
State of Massachusetts: The installation must be made
by a licensed plumber or gas fitter in the Commonwealth
of Massachusetts.
Sellers of unvented propane or natural gas-fired supple-
mental room heaters shall provide to each purchaser a
copy of 527 CMR 30 upon sale of the unit.
Appliance Certification
This logset is design certified in accordance with American National
Standard/CSA Standard ANSI Z21.88/CSA 2.33 and by Underwrit-
ers Laboratories for use with a Direct Vent Gas Fireplace Heater
and shall be installed according to these instructions.
33636-0-0314
GENERAL INFORMATION
Page 3
Advertisement
