Table of Contents
Advertisement
ALLPLEX Access Easy Master Controller
4
Installation of ALLPLEX AEMC
The ALLPLEX AEMC is based on a rackmount design. A rackmount bracket kit is included with
the panel. The rackmount brackets can be installed at the front or rear sides of the panel.
To aid the handling of the panel, the rack handles can be affixed to the brackets. The panel
can then be mounted on the rack. Before proceeding with installation, consider and decide
the type of rack you would be using, and the orientation of the mount (front or rear mounted).
Figure 4.1 Rackmount brackets and handles installed on the panel
4.1
Connecting the cables and powering up the panel
Once the ALLPLEX AEMC has been mounted on the rack, follow the instructions below to
establish the ALLPLEX AEMC on the customer's network.
1.
NOTICE!
Use the RJ45 port nearest to the power switch as shown in Figure 3.2. Do not use the other
RJ45 port.
2.
3.
4.
Once ALLPLEX AEMC is powered, the PWR LED (item 2 of Figure 3.1) should be lighted up.
Robert Bosch (SEA) Pte Ltd
Connect a network cable from the RJ45 port nearest to the power switch (item 3 of
Figure 3.2) on the panel to the customer's network hub.
Connect the power adapter from the DC-in jack (item 2 of Figure 3.2) on the panel to the
electrical outlet.
Turn on the electrical outlet.
Set the power switch of the panel on (item 1 of Figure 3.2).
Quick Installation Guide
Installation of ALLPLEX AEMC | en
F.01U.251.137 | V1.0.0 | 2011.08
9
Advertisement
Table of Contents
