Table of Contents
Advertisement
10
en | Installation of ALLPLEX AEMC
4.2
Default settings of the panel
The ALLPLEX AEMC comes preconfigured with default settings. Once the panel is powered
up, these settings come into effect. The default IP settings for the panel are as follows:
Setting
IP Address
Subnet Mask
Gateway
Table 4.1 Default IP Settings for ALLPLEX AEMC
If the customer uses their own network address settings, the IP settings for ALLPLEX AEMC
can be changed by logging into ALLPLEX AEMC using the default master User ID. The default
master User ID and Password are as follows:
User ID
iuser1
Table 4.2 Default master User ID and Password for ALLPLEX AEMC
This default master User ID is usually assigned to the network's System Administrator. The
access rights of this User ID cannot be disabled. However, the User ID and Password can be
changed from ALLPLEX AEMC.
WARNING!
Do not forget any changes made to the default master User ID and/or Password. If you don't
remember them, the information cannot be retrieved on-site. You will need to send the
ALLPLEX AEMC to the Bosch Service Center.
After logging in, change the IP settings accordingly, and reboot the ALLPLEX AEMC. Once
rebooted, ALLPLEX AEMC will respond to its new IP address.
For further information on changing the default software configuration, please refer to the
ALLPLEX AEMC Software Manual.
4.2.1
Retrieving configured IP settings of the panel
If changes were made to the IP settings of the ALLPLEX AEMC but you cannot remember the
details, use the IP Setup program to retrieve them on-site.
NOTICE!
The IP Setup program can be installed from the Uitlity CD included with the ALLPLEX AEMC.
Please refer to Section 5.1 Running IP Setup of the Utilities Program Manual.
F.01U.251.137 | V1.0.0 | 2011.08
Value
129.2.0.42
255.255.0.0
0.0.0.0
Password
8088
Quick Installation Guide
ALLPLEX Access Easy Master Controller
Robert Bosch (SEA) Pte Ltd
Advertisement
Table of Contents
