Advertisement
Quick Links
Advertisement
Related Manuals for Amtrol XLink Control
Summary of Contents for Amtrol XLink Control
- Page 1 IoT Well Management System Additional Information for Install X L i n k...
- Page 2 Wi-Fi Requirements The XLink Control requires a Wi-Fi connection to take full advantage of features. The XLink Control is a NEMA 3R rated housing, enabling the control to be installed both indoors and outdoors. It is recommended that the XLink Control be installed near the pressurized well tank. This will allow the sensor in the XLink Control to read the most accurate pressure for an optimized system application.
-
Page 3: Initial Startup
Note: If the startup sequence does not turn on the pump within 5 minutes, carefully relieve any residual pressure in the system to below 5 psi. See following page for more information. 4. The XLink control will automatically charge the tank to the determined pressure range based of the pre-charge. - Page 4 It is recommended that a licensed professional follows federal, state and local codes when installing the control. When installing the XLink control onto a system with an existing pressure tank, there is a possibility the pressure tank will retain some water pressure within the diaphragm during draining.
- Page 5 SENSITIVE. Once successfully connected, return to your XLink app and proceed in the connection process. 1. Once back in the Amtrol app, select the “Connected to Amtrol WiFi” button to move onto connecting a home router. 2. Select the home router and enter the home Wi-Fi password. Password is case sensitive.
- Page 6 How to add a photo of your install (homeowner): 1. Select the “Diagnostics” tab from the home screen 2. Select “Notes” from the options at the bottom When in notes, select the “+” at the top to add a note. This note can contain any information you’d like.