Advertisement
Quick Links
SAL SLIM AREA LIGHT
Risk of Fire
Fixtures are rated for use in
120-347V, 277-480V,
50-60Hz protected
circuit and 90°C rated supply wire.
INSIDE BOX
75SW/100W/150W
LED
Riesgo de incendio
Las luminarias están clasificadas para su uso
120-277V,
120-277V, 120-347V, 277-480V,
con
circuitos protegidos de 50-60 Hz y cables
adecuados para 90 °C.
LED Slim Area Light
240SW/320W
Made in China / Hecho en China / Fabriqué en Chine
Risque de feu
Les luminaires sont conçus pour une utilisation
120
277V, 120
de
à
pour un circuit protégé de 50 à 60 Hz et pour
une source d'alimentation de 90 °C.
ACCESSORY
（SOLD SEPARETELY）
Slip Fitter Mount 2 3/8" (MT-SAL/SF)
Pole Mount 6" (MT-SAL/PM6)
Installation Guide
V1.0
Page 1-5
347V, 277
480V,
à
à
Yoke Mount (MT-SAL/YK12)
Advertisement
Related Manuals for NA SAL SLIM AREA LIGHT
Summary of Contents for NA SAL SLIM AREA LIGHT
- Page 1 Installation Guide V1.0 Page 1-5 SAL SLIM AREA LIGHT Risk of Fire Riesgo de incendio Risque de feu Las luminarias están clasificadas para su uso Les luminaires sont conçus pour une utilisation Fixtures are rated for use in 120-277V, 120-277V, 120-347V, 277-480V,...
-
Page 2: Wiring Diagram
Installation Guide V1.0 Page 2-5 THREE ADJUST WATTS AND CCT BEFORE INSTALLATION（SUITABLE FOR 75SW&240SW） If you need to adjust watts and CCT, unscrew the screws to open the driver box cover plate, adjust according to the instruction in switch board, then close the plate and tighten screw. - Page 3 Installation Guide V1.0 Page 3-5 POLE MOUNT 6” (MT-SAL/PM6) φ0.47in Unscrew (1)M4 * 8 inner hexagon screw, install steel chain into the pole. Install gasket and Pole Mount 6” onto the pole with (2)M10 * 50 inner 2.2in Threading hole hexagon screws.
- Page 4 Installation Guide V1.0 Page 4-5 Pass wires through Slip Fitter. SLIP FITTER MOUNT 2 3/8“ (MT-SAL/SF) Pass wires through Slip Fitter. Pase los cables a través de Slip Fitter. Passez les fils à travers Slip Fitter. Fix SlipFitter onto fixture with (2)M6*18 inner hexagon screws.
- Page 5 Installation Guide V1.0 Page 5-5 Install the Yoke Mount on the wall. YOKE MOUNT(MT-SAL/YK12) Install the Yoke Mount on the wall. Instale el montaje del yugo en la pared. Installez le support Yoke sur le mur. Fix the decorating plate with (2)M6*18 inner hexagon screws, then install Yoke Mount to the fixture with (2)M10*25 inner hexagon screws.