Husqvarna K 770 VAC Operator's Manual page 57

1. Hold the starter rope pulley with your thumb. Pull the
starter rope approximately 30 cm and put it in the
cut-out of the starter pulley.
2. Let the rope pulley rotate slowly in the opposite
direction to release the spring tension.
3. Remove the remaining starter rope.
4. Do a check that the recoil spring operates correctly.
5. Put the new starter rope through the hole in the
starter housing and in the rope pulley.
6. Attach the starter rope to the rope pulley.
7. Tighten the connection fully. Make sure that the free
end of the starter rope is as short as possible.
8. Attach the end of the starter rope in the starter
handle as shown in the illustration.
705 - 003 - 22.04.2022
To adjust the tension of the recoil
spring
1. Put the rope through the cut-out in the starter pulley.
Wind the rope 3 turns clockwise around the center of
the starter pulley.
2. Pull the starter knob to adjust the tension of the
recoil spring.
3. Put the rope through the cut-out in the starter pulley.
Wind the rope 4 turns clockwise around the center of
the starter pulley.
4. Pull the starter knob to adjust the tension of the
recoil spring.
Note:
The starter knob moves into position after
the tension is adjusted.
5. Pull out the starter rope fully and make sure that
the recoil spring is not at its end position. Make the
starter pulley turn slow with your thumb.
6. Make sure that the starter pulley can be turned half
a turn or more before the recoil spring stops the
movements.
To remove the spring assembly
WARNING:
when you remove the spring assembly.
There is a risk for eye injury, especially if a
spring is broken.
Always use eye protection
57