Makita 5007NB Instruction Manual page 8

0
Blade installation
Blade installation is performed by revers-
ing the blade removal procedure.
a. Install inner flange on shaft.
b. Install blade.
c. Put on outer flange.
d. Install hex bolt.
This circular saw uses
a
saw blade with
a
hole diameter of 5/8". The recessed side
of inner flange
is
kept on the blade motor
side when mounting
(see
figure). Raise
the safetv ward as far as possible (i.e., as
T a
Inner flange- [ - . S a w blade
Fig.
7
, I
when removing the blade), then mount the blade on the shaft with the Makita name side
facing you.
Secure the hex bolt tightly, or the blade will slip and not turn.
CAUTIONS:
Use only the Makita standard-equipped wrench to install or remove the saw blade.
The use of other tools may cause dangerous looseness or tightness.
0
Adjusting cutting depth
To adjust the cutting depth, loosen the
clamp lever on the depth guide then hold-
ing down the base with on hand raise or
lower the body for the desired depth.
CAUTIONS
:
Use a shallow cutting depth when cutting
thin stock for cleaner, safer cuts.
After making the cutting depth adjust-
ment, always secure the clamp lever.
Fig.
8
8