Additional Safety Rules - Makita 5007NB Instruction Manual

VOLTAGE WARNING: Before connecting the tool to a power source (receptacle,
outlet, etc.) be sure the voltage supplied is the same as that specified on the
nameplate of the tool. A power source with voltage greater than that specified
for the tool can result in SERIOUS INJURY to the user
-
as well as damage t o
the tool.
If in
doubt, DO NOT PLUG
IN
THE
TOOL.
Using a power source with
voltage less than the nameplate rating is harmful t o the motor.
ADDITIONAL SAFETY RULES
1. Wear hearing protection.
2.
Keep Guards In Place and In Working Order.
Never wedge or tie lower guard open. Check operation of lower guard before
each use. Don't use
if
lower guard does not close briskly over saw blade.
CAUTION:
If saw is dropped, lower guard may be bent, restricting full return.
3. Do not use blades which are deformed or cracked.
4. Do not use blades of high speed steel.
5. Keep Blades Clean and Sharp.
Sharp blades minimize stalling and kickback.
6.
DANGER: Keep Hands Away From Cutting Area.
Keep hands away from blades. Don't reach underneath work while blade is
rotating. Don't attempt t o remove cut material when blade
is
moving.
CAUTION: Blades coast after turn off.
Large panels must be supported as shown in Fig.
1 to
minimize the risk of
blade pinching and kickback.
When cutting operation requires the resting of the saw on the work piece,
the saw shall be rested on the larger portion and the smaller piece cut off.
7. Support Large Panels.
To avoid kickback, do support board
or panel near t h e cut.
Fig. 1
Don't support board or panel away
from
t h e
cut.
8.
Use Rip Fence.
Always use a fence or straight edge guide when ripping.
4
Fig. 2