High Pressure Hose; Suction Hose - Craftsman CMCPW1500 Instruction Manual

2x20v max cordless pressure washer

Hide thumbs

Table Of Contents

Table of Contents

Available languages

English

hot/Cold Pack Delay

When the charger detects a battery pack that is too hot

or too cold, it automatically starts a Hot/Cold Pack Delay,

suspending charging until the battery pack has reached an

appropriate temperature. The charger then automatically

switches to the pack charging mode. This feature ensures

maximum battery pack life.

A cold battery pack may charge at a slower rate than a warm

battery pack.

The hot/cold pack delay will be indicated by the green

light(s) continuing to blink but with the red light

continuously ON. Once the battery pack has reached an

appropriate temperature, the red light will turn OFF and the

charger will resume the charging procedure.

Electronic Protection System

Li‑Ion tools are designed with an Electronic Protection

System that will protect the battery pack against overloading,

overheating or deep discharge. The tool will automatically

turn off and the battery pack will need to be recharged.

Important Charging Notes

1. Longest life and best performance can be obtained if

the battery pack is charged when the air temperature

is between 65 °F – 75 °F (18 ° C– 24 °C). DO NOT charge

when the battery pack is below +40 °F (+4.5 °C), or

above +104 °F (+40 °C). This is important and will

prevent serious damage to the battery pack.

2. The charger and battery pack may become warm to the

touch while charging. This is a normal condition, and

does not indicate a problem. To facilitate the cooling of

the battery pack after use, avoid placing the charger or

battery pack in a warm environment such as in a metal

shed or an uninsulated trailer.

3. If the battery pack does not charge properly:

a. Check operation of receptacle by plugging in a lamp

or other appliance;

b. Check to see if receptacle is connected to a light

switch which turns power off when you turn out

the lights;

c. If charging problems persist, take the tool, battery

pack and charger to your local service center.

4. You may charge a partially used pack whenever you

desire with no adverse effect on the battery pack.

Charger Cleaning Instructions

WARNING: Shock hazard. Disconnect the charger

from the AC outlet before cleaning. Dirt and grease

may be removed from the exterior of the charger using

a cloth or soft non‑metallic brush. Do not use water or

any cleaning solutions.

Wall Mounting

Some CRAFTSMAN chargers are designed to be wall

mountable or to sit upright on a table or work surface. If wall

mounting, locate the charger within reach of an electrical

outlet, and away from a corner or other obstructions which

may impede air flow. Use the back of the charger as a

template for the location of the mounting screws on the wall.

Mount the charger securely using drywall screws (purchased

separately) at least 1" (25.4 mm) long, with a screw head

diameter of 0.28–0.35" (7–9 mm), screwed into wood to an

optimal depth leaving approximately 7/32" (5.5 mm) of the

screw exposed. Align the slots on the back of the charger

with the exposed screws and fully engage them in the slots.

nOTE: Do not attempt to mount CMCB101 charger under a

bench or table.

nOTE: Only mount CMCB101 charger with the charging

lights pointed upward toward the ceiling.

VersaTrack™

WARNING: Do not charge batteries while charger is

hung on Trackwall.

CRAFTSMAN chargers, except the CMCB101, can be

stored on CRAFTSMAN VersaTrack™ Trackwall. Hooks and

accessories are sold separately. Please refer to the VersaTrack™

Trackwall accessory sheet for further information.

nOTE: The CMCB101 charger is not CRAFTSMAN VersaTrack™

Trackwall compatible.

SAVE THESE INSTRUCTIONS FOR

FUTURE USE

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of serious personal

injury, turn unit off and remove the battery pack

before making any adjustments or removing/

installing attachments or accessories. An accidental

start‑up can cause injury.

SPECIFICATIONS

Maximum Pounds per Square Inch

Rated Gallons per Minute

Battery