Advertisement
6) Unplug both ends of the COM cable (040-383-00), located between the front panel Display board (A)
and the Card Cage board (B). Cable ties hold the COM cable in place. Leave the cable inside the
HDR24/96 in case the OPT•24 is ever removed and the COM cable needs to be reconnected.
7) Connect the 2 short/fat ribbon cables (supplied) to the 2 bottom connectors (J3B and J4B, furthest
from the edge) on the OPT•24. The connectors have a keying tab in the center so they can't be
plugged in wrong. It doesn't matter which end of the ribbon cables you connect to the OPT•24.
8) Connect the 2 ribbon cables that you removed from the Sync card to the 2 top connectors (J3A and
J4A, closest to the edge) on the OPT•24. They will click in place when properly inserted.
OPT¥24 Board
4
OPT•24
REAR PANEL
REAR PANEL
2000
©
™
DESIGNS.
MACKIE
®
B
FRONT PANEL
J3B
8) Connect 2 Ribbon Cables
to OPT¥24 Board
REAR PANEL
REAR PANEL
2000
©
™
DESIGNS.
MACKIE
®
FRONT PANEL
6) Remove the COM Cable
from the Display Board (A)
and the Card Cage Board (B)
A
J4B
Advertisement
