Mackie 1402 VLZ Owner's Manual page 39

Haas effect
A psychoacoustic effect in which the time of
arrival of a sound to the left and right ears af-
fects our perception of direction. If a signal is
presented to both ears at the same time at the
same volume, it appears to be directly in front
of us. But if the signal to one ear, still at the
same volume, is delayed slightly (0 to 5 msec),
the sound appears to be coming from the ear-
lier (non-delayed) side.
headroom
The difference between nominal operating
level and peak clipping in an audio system. For
example, a mixer operating with a nominal line
level of +4dBu and a maximum output level of
+22dBu has 18dB of headroom. Plenty of room
for surprise peaks.
Hertz
The unit of measure for frequency of oscilla-
tion, equal to 1 cycle per second. Abbreviated
Hz. KHz is pronounced "kay-Hertz" and is an
abbreviation for kilohertz, or 1000 Hertz.
house
In Sound Reinforcement parlance, "house"
refers to the systems (and even persons) re-
sponsible for the primary sound reinforcement
in a given hall, building, arena or "house." Hence
we have the house mixer or house engineer, the
house mix, the house mix amps, the main house
speakers and so on.
Hz
See Hertz.
impedance
The A.C. resistance/capacitance/inductance
in an electrical circuit, measured in ohms. In
audio circuits (and other AC circuits) the im-
pedance in ohms can often be much different
from the circuit resistance as measured by a
DC ohmmeter.
Maintaining proper circuit impedance rela-
tionships is important to avoid distortion and
minimize added noise. Mackie input and output
impedances are set to work well with the vast
majority of audio equipment.
input module
A holdover from the days when the only way
that real consoles were built was in modular fash-
ion, one channel per module. See channel strip.
knee
A knee is a sharp bend in an EQ response
curve not unlike the sharp bend in your leg.
Also used in describing dynamics processors.
level
Another word for signal voltage, power,
strength or volume. Audio signals are some-
times classified according to their level.
Commonly used levels are: microphone level
(–40dBu or lower), instrument level (–20 to
–10dBu), and line level (–10 to +30dBu).
line level
A signal whose level falls between –10dBu
and +30dBu.
main house speakers
The main loudspeakers for a sound rein-
forcement system. These are usually the
largest and loudest loudspeakers, and are usu-
ally positioned so that their sound seems to
come from the area of the main stage.
mains
See main house speakers.
master
A control affecting the final output of a mixer.
A mixer may have several master controls, which
may be slide faders or rotary controls.
mic amp
See mic preamp.
mic level
The typical level of a signal from a micro-
phone. A mic level signal (usually but not
always coming from a microphone) is gener-
ally below –30dBu. With a very quiet source (a
pin dropping?) the signal can be –70dBu or
lower. It is also possible for some microphones
to deliver more signal than this, in which case
it may be referred to as a "hot" mic level. Alter-
natively, you can just say, "Boy, is that loud!"
mic pre
See mic preamp.
mic preamp
Short for microphone preamplifier. An ampli-
fier that functions to bring the very low signal
level of a microphone (approximately –50dBu)
up to line level (approximately 0dBu). Mic
preamps often have their own volume control,
called a trim control, to properly set the gain for
a particular source. Setting the mic preamp
gain correctly with the trim control is an es-
sential step in establishing good noise and
headroom for your mix.
39