Husqvarna LB 548i Operator's Manual page 20

To set the product in operation position
(LC 551iV)
1. Lift the handle to upright position.
2. Move the knobs up in the direction of the handle until
they stop and you hear a click.
3. Tighten the knobs fully.
To set the cutting height (LB 548i,
LC 551iV)
The cutting height can be adjusted in 6 levels.
1. Push the cutting height control in the direction of
the wheel and then rearward to increase the cutting
height.
20
2. Push the cutting height control in the direction of
the wheel and then forward to decrease the cutting
height.
CAUTION:
too low. The blades can hit the ground if the
surface of the lawn is not level.
To set the cutting height (LB 553iV)
The cutting height can be adjusted in 5 levels.
1. Move the cutting height lever rearward to increase
the cutting height.
2. Move the cutting height lever forward to decrease
the cutting height.
CAUTION:
too low. The blades can hit the ground if the
surface of the lawn is not level.
Battery
WARNING:
you must read and understand the safety
chapter. You must also read and understand
the operator's manual for the battery and the
battery charger.
Battery status
The display shows the remaining battery capacity and if
there are problems with the battery. The battery capacity
is shown for 5 seconds after the product is switched off
or the battery indicator button is pressed. The warning
Do not set the cutting height
Do not set the cutting height
Before you use the battery,
1630 - 004 -