Touch Panel Is Malfunctioning - Brother SE700 Operation Manual

Care and Maintenance
i Grasp the bobbin case, and then pull it out.
j Use the cleaning brush or a vacuum cleaner to remove
any lint and dust from the race and bobbin thread
sensor and the surrounding area.
c
1 Cleaning brush
2 Race
3 Bobbin thread sensor
IMPORTANT
• Do not apply oil to the bobbin case.
Insert the bobbin case so that the  mark on the
k
bobbin case aligns with the
a
b

• Align the  and
marks.
1  mark

2
mark
3 Bobbin case
• Make sure that the indicated points are aligned
before installing the bobbin case.
Insert the tabs on the needle plate cover into the
l
needle plate, and then slide the cover back on.
Reattach the bobbin cover.
84
a

mark on the machine.
a b
c
CAUTION
• Never use a bobbin case that is scratched or has
a burr on it. Otherwise the upper thread may
become tangled, the needle may break and cause
injury. For a new bobbin case, contact your
nearest Brother authorized service center.
• Be sure that the bobbin case is correctly
installed, otherwise the needle may break and
cause injury.

Touch panel is malfunctioning

If the screen does not respond correctly when you touch a key
(the machine does not perform the operation or performs a
different operation), follow the steps below to make the
proper adjustments.
a Holding your finger on the screen, turn the main
power switch to OFF and back to ON.
 The touch panel adjustment screen is displayed.
b Lightly touch the center of each +, in order from 1 to 5.
c Turn the main power to OFF, then turn it back to ON.