Caring For Your Microtalk - Cobra microTALK PR 255 VP Owner's Manual

9508-PR255-2VP-D-FinalC #17
I I n n t t r r o o d d u u c c t t i i o o n n Operation Customer Assistance Warranty

Caring for Your microTALK

® Radio
Your microTALK ® radio will give you years of trouble-free service
if cared for properly. Handle the radio gently. Keep the radio away
from dust. Never put the radio in water or in a damp place. Avoid
exposure to extreme temperatures.
Rechargeable Batteries
R R e e m m o o v v e e B B e e l l t t C C l l i i p p
and Charger
To install or replace batteries:
1. Remove belt clip by releasing belt clip
latch and sliding clip up.
P P u u l l l l U U p p L L o o c c k k L L a a t t c c h h
2. Pull up on the battery door latch to
remove the battery compartment cover.
3. Insert the supplied four (4) AAA rechargeable
batteries (also works with non-rechargeable
I I n n s s e e r r t t B B a a t t t t e e r r i i e e s s
alkaline batteries). Position batteries
according to polarity markings.
4. Replace battery compartment cover and
belt clip.
To charge batteries in radio:
Radio Charger Jack
1. Check to see that the batteries have been
inserted properly. See above for battery
installation instructions.
2. Insert round connector of wall charger/adapter into the charge jack
located at the top of the radio. The wall charger/adapter has two
round connectors which enables you to charge either one or two
radios at a time.
3. Plug the wall charger/adapter into electrical outlet.
It normally takes 15 hours to fully recharge batteries. It is not
recommended to recharge batteries more than 24 hours. Estimated
operation time on a full charge is 8 hours.
Use only the supplied rechargeable batteries and wall charger/adapter
for recharging your Cobra microTALK ® radio. Non-rechargeable alkaline
batteries can also be used.
N N o o t t h h i i n n g g Comes Close to a Cobra
3/29/06 3:36 PM Page 1
• •
• •
® 1 1