Bosch HDS8045C Installation Manual page 18

Connecting the three-wire range cord (alternate
method)
The four-wire connection (above) is preferred, but where
local codes and ordinances permit grounding through
the neutral and where conversion to four-wire is
impractical, the unit can be connected to the power
supply via a three-wire connection.
Disconnect the electrical power at the breaker box.
1.
Remove the terminal block cover to expose the
terminal block.
Remove the metal plate. Rotate it 180° to have the
2.
lager hole for the power supply cable and mount it
again.
Insert the power supply cable into the terminal block
3.
through the bottom hole.
Insert the flat washer.
4.
Attach the red wire to the left junction block terminal
5.
using one of the hexagonal nuts.
Attach the white wire to the center junction block
6.
terminal using one of the hexagonal nuts.
Attach the black wire to the right junction block
7.
terminal using one of the hexagonal nuts.
18
Properly secure strain relief.
8.
WARNING
9
WARNING
The strain relief provided with your range cord
must be installed correctly.
Tighten all connections securely and replace terminal
9.
block cover.
Note: Do not plug in the range at this time.
Connecting the four-wire flexible conduit
Disconnect the electrical power at the breaker box.
1.
Remove the terminal block cover to expose the
terminal block.
Insert the power supply cable into the terminal block
2.
through the bottom hole.
Remove the grounding strap from the center post on
3.
the terminal block. Therefore remove the hexagonal
nut of the neutral pin. Remove the fork type connector
of the groundling link. Mount the hexagonal nut on the
neutral pin again. Remove the green hexagonal screw
and the ring connector from the grounding. The strap
will not be needed. Remove it from the unit.
Attach the insulated grounding wire to the grounding
4.
hole with the green grounding screw. Tighten the
green hexagonal nut firmly, but do not overtighten.