Table of Contents
Advertisement
6
Camera battery warning
7
8
9
10
ImageBank-ll battery warning
5
Battery warning on sensor unit
When the remaining power in the battery drops below a certain
point, a warning icon appears on the sensor unit display screen as
well as on the grip LCD. In addition, an audible signal can be heard.
The warning on the display screen appears as a flashing yellow icon
in the top right of the screen signifying that the battery should be
charged (or changed) as soon as possible. The warning icon will also
appear with a FireWire connection and will in addition turn red to
signify that the camera battery is completely exhausted.
Another battery warning also appears signifying ImageBank-11
battery exhaustion. This icon appears on the top left of the display
screen. It too flashes yellow as the initial warning and changes to
red to signify complete exhaustion.
IAA toggle
Any of the USER, AE-L, STOP DOWN and M.UP buttons on the
camera can now be reassigned to function as an IAA button (Instant
Approval Architecture) on the sensor unit. The reassigned button
can then be toggled to classify new captures in the normal manner
as when pressing the IAA button.
Delete last image
The 'Delete last image' has now been implemented to the customiz-
able button function list. Consequently by just pressing the USER,
AE-L, STOP DOWN or M.UP button, you are now able to immediately
delete the last image. Please note that for this action to be carried
out, there should be no intervening action taken. So, for example,
if you zoom in to check the image you cannot then delete it using
this particular feature but must use the regular procedure on the
sensor unit.
Standby mode
It is now possible to turn the camera off directly from Standby
mode.
On / Off
The amount of time that the ON-OFF button must be depressed
before turning the camera on has been increased from 500 ms to
750 ms to avoid unintentional battery drain (inadvertently pressed
in a camera bag, for example).
Camera
The 'Camera' choice on the menu is now greyed out with the normal
H3D-ll body/sensor unit combination. It is active again when the
sensor unit is attached to another type of camera.
System Info
The "System info" section of the menu has an additional information
screen that displays the Ultra Focus calibration ID.
A matching ID can also be found in the sensor unit menu for op-
timum performance.
6
7
8
9
10
H3D-ll User Manual Supplement V6
Advertisement
Table of Contents
