Advertisement
The direction of this cutout is not fixed.
Top Plate
M6x30 Bolt
(Fig. I)
4
Install the Legs to the Lower Pillar.
All 4 legs are exactly the same.
One end has a reinforcement bracket inside in order
to avoid deforming the tube problem when the bolt is
over tightened. (see Fig. J)
Make sure if this bracket is fully inserted into the
tube. If it is missing, do NOT use and contact the
shop you purchased this product immediately.
If the bracket has
!
been twisted and
difficult to put
the bolt through,
adjust the bracket
angle first.
5
Place the legs in the shape of "X" and sandwich them
by Top and Bottom Plates then fix them by 8 M6x50
Bolts. (Use the holes indicated in black dots in Fig. E)
Put the bolt to the Leg from upper side, and tighten to
the thread hole with 6 N.m torque. (see Fig. K)
Any directions is OK.
Lower Pillar
!
Do not tighten just one
bolt.
Try to tighten each bolt
evenly.
Reinforcement
Bracket
(Fig. J)
(Fig. K)
About Foot Adjusters
The Foot Adjuster works to make this rack standing stable
and correctly vertical without any backlash.
Screw the Foot Adjuster to adjust the length.
Once the length is fixed, tighten the Lock Nut toward the
Leg fully and fix the position by the 13mm spanner.
- 4 -
!
Do not tighten
just one bolt.
Try to tighten
each bolt
evenly.
M6x50 Bolt
M6 Spring Wasaher
M6 Flat Washer
Bottom Plate
(Fig. L)
Advertisement
