Thinky AR-250 Operation Manual

Thinky AR-250 Operation Manual

Non-contact defoaming mixer

Advertisement

EX-1045B
THINKY
Non-contact Defoaming Mixer
AR-250 Operation Manual
THINKY CORPORATION
www.thinky.co.jp/english

Advertisement

Table of Contents
loading

Summary of Contents for Thinky AR-250

  • Page 1 EX-1045B THINKY Non-contact Defoaming Mixer AR-250 Operation Manual THINKY CORPORATION www.thinky.co.jp/english...
  • Page 2 (container spin) speed. It transits to de-foaming mode automatically if timer is set. 2-2. Memory Slot AR-250 has 5 memory slots to store your settings. It stores timer settings by mode. 2-3. Safety Feature 1) Lid Censer : It can not be run while the lid open. It can not be opened while it spins.
  • Page 3: Confirm Contents

    (Right and left side) Bottom Buffer Packing Tray 2. Confirm Contents Confirm each of following is included in the package. AR-250 Unit Operation Manual 3phase AC Power Code 250 ml HDPE jar 150 ml HDPE jar Adapter of 150 ml jar Rubber Ring of Adapter 8.
  • Page 4 procedure. Remove the Bottom Fixing Bracket Carefully lay the machine on its side. Remove the Bottom Fixing Bracket "A" by loosening the 6 screws(four M5x10 and two M5x30). as shown in Figure 3. £ Figure 3 ⁄ Remove the Rear Fixing Bracket Remove the Rear Fixing Bracket "B"...
  • Page 5 Store the Fixing Brackets Attach the Bottom Fixing Brackets A, the Rear Fixing Bracket "B", and the screws to the bracket holder holes on the back of the main body,as shown in Figure 5. £ Figure 5 ⁄ Caution The fixing brackets and screws are necessary for future transportation of the unit. Be sure to attach them back in the way shown above.
  • Page 6: Installation

    9. Installation Plug the AC power code in the unit (Photo A) the tap (Photo B). Photo A9 9 Photo B9 < Note > Use 2 phase adaptor as needed < Caution > Some regions regulate 2 phase connector. Please confirm your local law or regulations before use.
  • Page 7 Caution The Power supply cable of this product has a 3P plug with an earth pin. if the wall tap has an earth terminal, connect the cable plug directly into the tap without using the 3P adapter. hIf the wall tap does not have an earth terminal, use the 3P adapter to convert the plug to 4.
  • Page 8: Read Before Use

    WEIGHT 310 GRAM USE THINKY MANUFACTURERD ADAPTOR ONLY. The use of adaptors THINKY does not confirm the influence to the unit on balance voids warranty and THINKY may not accept maintenance service. USE INNER LID OF CONTAINER AND CLOSE THE SCREW CAP TIGHTLY to avoid leaking.
  • Page 9 ADJUST “Balance Adjuster” TO THE WEIGHT YOU MEASURED USE THINKY MANUFACTURERD ADAPTOR ONLY. The use of adaptors THINKY does not confirm the influence to the unit on balance voids warranty and THINKY may not accept maintenance service. KEEP CLEAN AND CLEAR AROUND THE UNIT ALL THE TIME NEVER ATTEMPT TO ADD MATERIALS INTO THE CONTAINER PLACCED IN THE “Cup Holder “...
  • Page 10: Basic Operation Flow

    150ml container : up to 150ml 250 ml container : up to 250 ml 3. Close the inner cap and outer cap. THINKY TIPS : Put materials in the following order for better result. 1) Liquid material first and then powder...
  • Page 11 Step 4 : Adjust “Balance Adjustor Dial” Very important 1. Adjust “Balance Adjustor Dial” to the weight you measured. 2. Confirm Weight indicator if it matches to the measured weight. Caution : Use “Balance Adjustor Dial” properly as instructed. If not, it will shorten the life of the unit or cause unexpected result to failure.
  • Page 12: Specifications

    39H 300W 290D(mm) Weight of the unit Approx. 22kg 11. Solve problems Please confirm which problems you have and apply the actions before contact THINKY representatives. In case the problem is not solved, please contact THINKY representative. Symptom Action Page 1) NO power -Plug the code out/in again.
  • Page 13: Error Messages

    When the cause of the error is known, remove the cause and press any button EXCEPT the Start Button on the Control Panel to restart the machine. When the cause is not clear and cannot be resolved, please contact your local dealer or Thinky. Error Cause...
  • Page 14 The Warranty period of this products is 1 year from the date of delivery. For failures that are apparently caused by reasons attributed to Thinky (failures due to cause in manufacturing), which occurred during this warranty period, Thinky will provide repair service free of charge.

Table of Contents