Table of Contents
Advertisement
Part 1: General Information
8.Body
8-1 Custom Functions:
No.
Custom Function
C01:
Film rewind mode
CO2:
Film leader position
C03:
Film speed setting
C04:
AE Lock and AF
COS:
Mirror lock & self-timer
C06:
Flash sync timing
C07:
AF-I lluminator
COS:
Partial metering and
FE lock linkage to
focusing point
C09:
Shutter speed setting
during Av AE or flash use
C10:
Focusing point flashing
C11:
Eye-activated D-o-F:
I]
Eleven Custom Functions are provided. The desired cus-
tom functions is selected by setting the Command
Dial
to
"CF" and turning the Main
Dial.
The custom function
can then be set by pressing the AE lock button.
Function
0: Automatic silent rewind at the end of the roll.
1: Automatic high-speed rewind at the end of the roll.
0: Rewinds the film leader into the cartridge.
1: Leaves the film leader outside the cartridge.
0: Film speed set automatically by the DX code.
1: Film speed set manually.
0: Enables AF operation by pressing the shutter button
halfway and enables AE lock with the AE lock button.
1: Enables AF operation by pressing the AE lock button and
enables AE lock by pressing the shutter button halfway.
2: Enables AF operation by pressing the shutter button
halfway and enables the AE lock button to stop down the
aperture.
{When either 1 or 2 is set, FE lock with Speedlite 380 EX
does not function.)
0: Enables normal self-timer and remote control operations.
1: Enables the shutter button (when pressed completely) to
lock up the mirror and release the shutter 2 sec. later.
(Mirror lockup is also possible with Remote Controller RC-1
set for a 2-sec. delay.)
0: Front-curtain synchronization.
1: Rear-curtain synchronization (with the built-in flash or
Speedlite 380 EX.)
0: Enables automatic emission of AF-llluminator.
1: Disables AF-llluminator.
0: Links partial metering and FE lock to the center.
1: Links partial metering and FE lock to selected focusing
point. If focusing point is set for automatic selection,
partial metering and FE lock will be linked to the center.)
0: Sets shutter speed automatically.
1: Sets shutter speed to 1/125 sec.
0: Enables focusing point flashing.
1: Disables focusing point flashing.
0: Enabled. (Enabled for six seconds after focus is achieved
in One-Shot AF mode.)
1: Disabled.
1-14
Hide quick links:
Advertisement
Table of Contents
