Wear Parts; Read-Only Memory; Fan; Ambient Conditions - Bosch Rexroth ctrlX CORE X7 Operating Instructions Manual

Table of Contents

Advertisement

12 / 50

Ambient conditions of the ctrlX CORE

5.8

Wear parts

5.8.1

Read-only memory

The physical read-only memory (eMMC) of the control has a limited number of write cycles. Retrieve the
current status of the read-only memory via the ctrlX CORE web interface:
Settings �� Information �� tab "Resources" �� Sensors" .
��
Notes on sensor values:
"0 - 10% of eMMC life time used" means that up to 10 % of the maximum write cycles can be used.
Create a backup if the value exceeds 80%.
Replace the hardware if the value exceeds 80%.
Use an external memory to extend the service life of the permanent memory.
The frequency of the refresh cycle depends on the service life of the memory. If a refresh cycle is
not possible anymore, data can be lost.
5.8.2

Fan

The maximum service life of the fan unit is 50,000 hours. The fan unit then needs to be replaced. For
the ordering data, refer to
6

Ambient conditions

6.1
Ambient conditions of the ctrlX CORE
Ambient temperature during operation
Ambient temperature during storage and transport -40 °C to +70 °C
Operating altitude acc. to DIN 60204
Permitted air humidity according to
DIN EN 61131-2
Protection class acc. to DIN EN 60 529
Protection class acc. to DIN EN 61010-2-201
Overvoltage category acc. to IEC 60664-1
Contamination level acc. to EN 61010-1
Mechanical tests
Vibration resistance acc. to DIN EN 60068-2-6
Shock test acc. to DIN EN 60068-2-27
Bosch Rexroth AG
⮫ Chapter 5.5 "Fan unit" on page
"ctrlX CORE side navigation
11.
Up to 2,000 m: -25 °C to +55 °C
2,000 m to 3,000 m: -25 °C to +50 °C
3,000 m to 4,000 m: -25 °C to +45 °C
4,000 m to 5,000 m: -25 °C to +40 °C
Up to 5,000 m above sea level
5% to 85%, no condensation
IP 20 (not evaluated by UL)
III
2
2, no condensation allowed
Oscillations, sinusoidal in all three axes
5 Hz - 8.4 Hz with 3.5 mm amplitude
8.4 Hz -150 Hz with 1 g peak acceleration
Shock stress: Shock resistance in all three axes, 11
ms semi-sinusoidal 15 g
ctrlX CORE X7
R911419122, Edition 01

Advertisement

Table of Contents
loading

Table of Contents