Table of Contents
Advertisement
9. To shut the unit down, press the ON/OFF
button.
Note: After a power outage, the unit will
memorize the last setting and return the unit
to the same setting once power is restored.
Fault Codes
1. If the display reads "AS" or "ES" , a sensor
has failed. Contact your Authorized
Frigidaire Service Center.
2. If the display reads "P2", Bucket is full or
removed or not in right position. Replace
the bucket in the right position.
OPERATING INSTRUCTIONS
Removing Collected Water
1. Emptying the Bucket:
a. When the bucket is full, the unit will shut
down and the BUCKET FULL indicator
will illuminate.
b. Do not move the unit at this time
otherwise water may spill on the floor.
c. Press sides of bucket gently to unclip
the bucket from the unit.
d. Remove the bucket as shown in the
photographs below and empty the
bucket.
9
Advertisement
Table of Contents
