Table of Contents
Advertisement
8
OPERATING INSTRUCTIONS
6. When the unit is on, first press the Timer
button, the Timer O indicator light
illuminates. It indicates the Auto Stop
program is initiated. Press it again the Time
On indecator light illuminates. It indicates
the Auto Start is initiated.
When the unit is o , first press the Timer
button, the TIMER ON indicator light
illuminates. It indicates the Auto Start
program is initiated. Press it again the Time
O indecator light illuminates. It indicates
the Auto Stop is initiated.
Press or hold the UP or DOWN pad to
change the Auto time by 0.5 hour
increments, up to 10 hours, then at 1 hour
increments up to 24 hours. The control will
count down the time remaining until start.
The selected time will register in 5 seconds
and the system will automatically revert
back to display the previous humidity
setting.
When the Auto start & Auto stop times are
set, within the same program sequence,
TIMER ON OFF indicator lights illuminate
identifying both ON and OFF times are
now programmed.
Turning the unit ON or OFF at any time or
adjusting the timer setting to 0.0 will
cancel the Auto Start/Stop function.
When LED display window displays the
code of P2, the Auto Start/Stop function
will also be cancelled.
NOTE:
1. Before entering TIMER setting, make sure
power is being supplied to the unit.
2. Before entering TIMER setting, make sure
pressing HUMIDITY
desired room humidity first.
7. The CLEAN FILTER light will illuminate
after 250 hours of operation. At this time
refer to the care and cleaning section to
remove and clean the filter. Once the filter
has been cleaned and replaced, simply
press the FILTER button to extinguish the
light.
8. When frost builds up on the evaporator
coils, the compressor will cycle o and the
fan will continue to run until the frost
disappears.
or
button sets one
Advertisement
Table of Contents
