System-Management Software Support - IBM Netfinity EXP300 Installation And User Manual

System-management software support

8
IBM® Netfinity® EXP300 Installation and User's Guide
Push pins Each ESM board has an orange push pin at the lower left of the board. Use
the orange push pin and lever to remove and insert the ESM board.
Termination-power LED (green)
When lit, this green LED indicates that termination power is present. When a
termination-power LED is lit, it indicates that the other end of the cable is
connected to a powered-on controller. Each external bus has a separate
termination-power LED.
LVD/SE LED (green)
When lit, this green LED indicates that the external host bus is in low voltage
differential (LVD) mode. When this LED is off, this indicates that the external
host bus is in single-ended (SE) mode. Each external bus has a separate
LVD/SE LED. Only LVD host bus controllers are supported.
SCSI bus connector
The 68-pin Very High Density Connector Interface (VHDCI) connectors are
for attaching your SCSI cables to SCSI bus 1 and SCSI bus 2.
Activity LED (green)
When lit, this green LED indicates there is activity on the external SCSI bus.
Each external bus has a separate activity LED.
The Netfinity EXP300 provides software alert functions through the system monitor
functions provided in the IBM Netfinity Manager, IBM Netfinity Director, and IBM
ServeRAID manager software.
The following alerts are supported:
• Disk drive disabled
• Power supply failure
• Cooling failure
• IBM Netfinity EXP300 too hot
• Vital Product Data for subcomponents
Note: You must have the correct level of system-management software on your
server to enable this functionality.
You must use ServeRAID Version 4.20 or later for your ServeRAID controller to report
status and alerts properly. To download the latest ServeRAID software, visit the IBM
web site at: http://www.ibm.com/pc/support
For up-to-date information about the IBM Netfinity Manager and Netfinity Director
software support available for your EXP300, visit the IBM Web site at:
http://www.ibm.com/pc/us/netfinity
For Netfinity Manager users, download Netfinity Manager Version 5.20.6 SP1 or later.
For Netfinity Director users, download Netfinity Director, UM Server extensions
Version 2.12 SP1.