Install Powervault Without Encryption; Prerequisites - Dell MD1400-16TB Setup Manual

Install PowerVault without Encryption

This topic describes how to install a PowerVault without encryption on NetWitness Series 5 and
Series 6 Decoder, Log Decoder, Concentrator, Archiver, and Hybrid physical hosts.

Prerequisites

Make sure that you have the following required software:
NetWitness Platform - The recommended versions are 11.5.0.0 and later.
l
To verify the version, in the Administration Services view (Administration > Services), the
release version is displayed to the right of each service listed. To check the version at the
command line, run the following command:
rpm -qa | grep nw
Results example:
rsa-nw-concentrator-11.5.0.0-11293.5.0c5da3886.el7.x86_64.rpm
Caution: If you are adding a previously used PowerVault and would like to preserve the data,
DO NOT follow the instructions in this guide. Contact NetWitness Customer Support.
Running the script on a previously used PowerVault could erase any existing data.
15
PowerVault (Dell MD1400 - 16TB) Setup Guide
Install PowerVault without Encryption