Mounting The Sonar Unit - Lowrance X37TX Installation And Operation Instructions Manual

power cable when the unit is not in use. When you are not using
the unit, you should always shut off power to the power cable,
especially when the power cable is disconnected from the unit.
To unit
Power and transducer connections for the X37TX and X47TX
sonar units (direct battery connection shown).
If possible, keep the power cable away from other boat wiring,
especially the engine's wires. This will provide the best isolation from
electrical noise. If the cable is not long enough, splice #18 gauge wire
onto it. The power cable has two wires, red and black. Red is the
positive lead, black is negative or ground. Make sure to attach the in-
line fuse holder to the red lead as close to the power source as possible.
For example, if you have to extend the power cable to the battery or
power buss, attach one end of the fuse holder directly to the battery or
power buss. This will protect both the unit and the power cable in the
event of a short. It uses a 3-amp fuse.
CAUTION:
Do not use this product without a 3-amp fuse wired into the power
cable! Failure to use a 3-amp fuse will void your warranty.
This unit has reverse polarity protection. No damage will occur if the
power wires are reversed. However, the unit will not work until the
wires are attached correctly.

MOUNTING THE SONAR UNIT

You can install the sonar unit on the top of a dash with the supplied
bracket.
Bracket Installation
Mount the unit in any convenient location, provided there is clearance
when it's tilted for the best viewing angle. You should also make sure
there is enough room behind the unit to attach the power/transducer
cable. (See the following drawings, which show the dimensions of a
mounted X37TX or X47TX.)
Optional power off switch
for saltwater installations
Black wire
16
Red wire with
12 volt
3 amp fuse
battery