–
Together with an assistant, take the vehicle off the pallet.
–
Position the vehicle on a lift stand.
–
Check the vehicle and components for transport damage.
Info
The procedure in the event of transport damage is
described in the Customer Service Manual.
–
Install the shock absorber. (
402051-01
–
Position turn signal indicator lamp
instrument rack.
H01768-10
–
Position the connector board and combination instrument
on the upper triple clamp.
–
Mount and tighten screws
Guideline
Remaining screws,
chassis
–
Route the clutch line with the clutch master cylinder
toward the front between the upper and lower triple
402736-10
clamps.
–
Install the fork legs. (
(EXC‑F EU/US, XCF‑W)
–
Remove screws
–
Move the handlebar supports to the desired position and
mount and tighten screws
Guideline
Screw, handle-
bar holder
Info
Position the left and right handlebar supports
evenly.
S01414-10
p. 22)
1
in the combination
2
.
M6
10 Nm (7.4 lbf ft)
p. 22)
3
and take off the handlebar supports.
3
.
M10
40 Nm (29.5 lbf ft)
Loctite
SETUP 2
®
243™
5