Husky FC125LV Use And Care Manual page 9

Operation Instruction (continued)
3
Setting Up the Welding Wire
□
Release the drive roll pressure arm (7) by lifting up the
pressure arm adjustment knob (6).
□
Rotate the drive roll knob (8) counterclockwise to remove it.
Figure 2
(See . and
□
Check your drive roll (9). Ensure it matches with your
welding wire.
Note: Drive roll (9) has two grooves. The top groove is the
one that feeds welding wire.
□
Place the drive roll knob (8) back and rotate clockwise to
tighten it.
□
Before inserting your wire into the wire feeder, ensure your
wire end is straight. Cut the bent end with wire cutters if
necessary.
□
Feed your wire into the wire inlet guide tube (5) of the wire
feeder and line the wire up with the TOP groove of the drive
roll. Push the wire across the drive roll and into the other
side of the wire feeder.
□
Pull the pressure arm adjustment knob (6) back and lock it
by pushing the drive roll pressure arm (7) down.
□
Remove the nozzle from the end of the flux core gun.
□
Remove the contact tip at the tip of the gun by unscrewing
in counterclockwise direction.
□
Plug the welder and switch the ON/OFF switch to ON.
Ensure you are not pointing the flux core gun at yourself
and any bystanders.
□
Press the trigger on the flux core gun. Feed the wire
continuously until at least one inch of the wire extends out
of the gun.
□
Check if the drive roll is feeding the wire properly. If the
drive roll is slipping on the wire, increase pressure on the
pressure arm adjustment.
□
Check the contact tip and ensure it matches the welding
wire. Install the contact tip back to the flux core gun.
□
Attach the flux core nozzle back to the gun.
□
Cut off the over-extended wire that sticks out of the flux
core gun if needed.
.
Figure 3.
)
5
Figure 2. Wire Feeder
Figure 3. (i) Locked Wire Feeder, (ii) Released Drive
Roll Pressure Arm, (iii) Removed Drive Roll Knob
9 Please contact 1-888-43-HUSKY for further assistance.
6 7
i
ii
iii
HUSKYTOOLS.COM
8
9
8