Changing The Camera Address Settings; Dip Switch Address Chart - Lorex SG7381 Instruction Manual

Changing the Camera Address Settings

NOTE: This is only applicable when using the BNC Adaptor cable. CH1 is the only available channel if
using the DIN Connection.
The DIP switches inside the camera can be changed to set a unique address for the Camera (set to 1 by
default). The address range is between 1~255:
•
If using a single camera, the address does not need to be changed. Refer to the Hardware
Manual for the Observation System for camera channel placement and configuration.
•
If using multiple cameras, each camera must be set to a unique address using the internal DIP
switches. The DIP switches shown below.
To access the DIP switches:
1. Remove the Dome Cover.
2. Use the chart below to set the desired address. Set the dip switches (ON is up; OFF is down)
using a paperclip or other pointed tool.

DIP Switch Address Chart

Changing the Camera Address Settings
Default Configuration: Switch 1 is ON, and
all other switches are off. The address is '1'
9