DSC AMP-700 Installation Instructions

Addressable magnetic door/window contact

Download this manual

AMP-700

Addressable Magnetic Door/Window Contact

INSTALLATION INSTRUCTIONS

The AMP-700 contact uses a 2-wire connection for power and to

communicate with the control panel. This, in combination with low power

devices, simplifies wiring and reduces device count for fast and efficient

installations.

The AMP-700 has a magnetic contact and an internal tamper switch so as

to monitor both the alarm and tamper states.

Specifications

Current Rating .................................................................................... 0.8mA

Operating Environment ....................................... 0°C - 49°C (32°F - 120°F)

.................................................................... 5% - 95% RH, non-condensing

Size (H x W x D) .................................. 27 x 85 x 19mm / 1

Control Panel Compatibility

PC4010/4020 v3.x

PC5010/PC5015 v2.x with PC5100 interface module

Connection Diagram

Run the connection wires through the wiring holes on the back of the unit.

Mounting

To mount the unit, remove the plastic cover and secure the unit to the

desired location with the screws provided. Replace the cover.

Mount the magnet next to the reed switch, as shown in the diagram

above.

Device Enrollment

The serial number located on the back of the device must be enrolled into the

alarm control panel via Installer's Programming ([ ] [8] [Installer's Code]).

This procedure is outlined for the PC4010/4020 in the control panel

Installation Manual and for the Power panels in the PC5100 Installation

Manual.

WARNING: Connect only DSC Addressable Series devices to the

addressable loop connections. Connection of ANY other type of device will

impair operation. Any devices other than Addressable Series devices

which require power to operate must be powered separately.

x 3

in.

Page 1 This, in combination with low power devices, simplifies wiring and reduces device count for fast and efficient installations. The AMP-700 has a magnetic contact and an internal tamper switch so as to monitor both the alarm and tamper states. Specifications Current Rating ..................
Page 2 FCC COMPLIANCE STATEMENT CAUTION: Changes or modifications not expressly approved by Digital Security Controls Ltd. could void your authority to use this equipment. This equipment generates and uses radio frequency energy and if not installed and used properly, in strict accordance with the manufacturer’s instructions, may cause interference to radio and television reception.