Lorex LW2101 Quick Start Manual

ULTRA DIGITAL WIRELESS VIDEO
MONITORING SOLUTION
LW2100 - qUIck sTarT gUIde
Getting Started
*
This Ultra digital Wireless Video
Monitoring solution comes with the
following components:
• digital Wireless color camera*
• camera stands*
• Wireless receiver
• Wireless antenna's for camera*
and receiver
• Power adaptors for camera*
and receiver
• BNc/rca adapter
• BNc / BNc 3ft extension cable
• Mounting Hardware
• Instruction Manual
* Number of cameras may vary by
model. Check your package for
specific content information.
www.lorexcctv.com
NOTe: aVOId INsTaLLINg IN a LOcaTION
WHIcH reqUIres THe WIreLess sIgNaL
TO Pass THrOUgH ceMeNT, cONcreTe
aNd MeTaL sTrUcTUres. THIs WILL
redUce THe TraNsMIssION raNge.
A. Connect the Camera
1 Mount camera stand to the wall.
NOTE: Before you install a camera, carefully plan where
and how it will be positioned, and where you will route the
cable that connects the camera to the power adaptor.
Before starting permanent installation, verify its
performance by observing the image on a monitor when
the camera is positioned where it will be permanently
installed.
B.
Connect the Receiver to an Observation System / Recorder (DVR) or TV
attach the 3
1
included
antenna to
the receiver
1
by screwing
it on.
2
OPTIONAL
2 If the receiver is not able
to directly plug into your
C.
TV or recorder because
of space constraints or
OPTIONAL
blockage of wireless
signal, use the included
BNc/BNc extension The system comes with a camera that has already been paired. The Pairing Function assigns each camera to a different channel on
the Wireless receiver (up to 4 cameras), and is necessary for configuring additional cameras. By default, the camera included with
cable to reposition the
the system appears on channels 1 on the wireless receiver. Please refer to the included Owner's Manual for detailed steps.
receiver.
2
secure camera to the mounting stand.
adjust the angle of the camera until
the desired view is set. Tighten the
thumbscrews to secure the desired
camera position.
NOTE: Wireless cameras require a power
source to operate.
NOTE: When adding cameras that were not
included in the original box, you will need to
pair up the camera with the receiver. Please
refer to the camera Pairing section of the User
Manual.
Connection Options:
Observation Monitor or Recorder (DVR) with
BNC input:
Plug the BNc connector of the receiver directly
into the monitor or dVr.
TV with RCA Inputs:
attach the included BNc/rca adapter to the
BNc plug on the receiver. Plug the receiver into
the TV.
Adding Additional Cameras
under 15 minutes under 30 minutes
Hand Tools
Time Tools Skills - Easy
Under 15 Minutes*
* Installation time may vary Hand Tools
based on application and
camera location
Skill Level
easy Intermediate
3
connect one end of the camera
Power adapter to the camera
and the other end to an
electrical outlet.
connect power adaptor to local
120V ac power outlet
connect one end of the receiver
4
Power adaptor to the receiver
and the other end to an electrical
outlet.
ATTENTION: Make sure to first connect
and power on the camera before powering
on the receiver; this will ensure a proper
connection.
LW2100 Quick Start Guide_R1
under 60 minutes over 60 minutes
Skill Level
Hardware
Hi Speed
Router
easy Intermed
Plug & Play connections,
On screen set up
advanced
Page 1