Carrier XCT Series Installation And Owner's Manual page 17

Installation Procedures
no less
than
150mm
• The condensate drainage pipe should be over 1% gradient. And it should be wrapped with heat insulation pipe.
Choice of Blowing Wind from Blower
The blower is provided with a red terminal and a white terminal. The standard wind choice has been set before
delivery. When the use of optional components, such as the high performance filter, causes the static pressure rising,
change the connection of the connector mounted on the side of the control cabinet, as shown below.
standard blowing wind (at delivery)
Yellow
Black Orange
Blue
Red
Cautions: The indoor units of this series are low pressure duct type. Please contact the professional design and
after-sales service people for the following items: calculate the heat load and the external static pressure, choose the
correct return outlet, air return pipe , air discharging outlet and air discharging pipe.
wall
no less
150mm
front
no less than
1000mm
(when using the high performance filter)
high-speed blowing wind
Yellow Yellow
Black
Black Blue
Blue Red
than
Yellow
Black
Blue
Red
9
top side
no less than 1750mm
ground
Static Pressure Range
unit: Pa
Standard Max.
Static Static
Pressure Pressure
0 30