Panasonic CT-30WX54J Service Manual page 88

Some tie-wraps that secure the wire dressings may need to be unfastened for chassis removal.
D-Board - Deflection
The D-Board assembly rest on a chassis tray along with the A-Board.
Slide chassis tray out. Gently lift the tray and pull out. Disconnect plug connectors; release wire ties
and holders as required for complete chassis removal.
1. D-Board is secured to the chassis tray with screws.
2. The D-Board is mated to the A-Board and G-Board by flexible connectors: D6, D7 & D8 (A6,
A7 & A7 on the A-Board, respectively) and D9 (G40 on the G-Board). To remove either
boards, unplug the connectors.
NOTE
Some tie-wraps that secure the wire dressings may need to be unfastened for chassis removal
L-Board - CRT output
Plugs into the socket on the CRT neck.
To remove this board, first unplug the board from the CRT neck, then disconnect L1, L2 and L3
connectors, to disconnect the focus F1(red cable) & F2 (white cable) cables from the CRT socker, pull
the tab and release the cables (see figure).Disconnect L10, L11, L12, L14 & L15 by inserting a wire in
both holes then pull the cable out.
To reinsert back the cables, remember the original position of cables, F1 (red cable) goes to A on the
CRT socket and F2 (white cable) goes to B on the CRT socket.
DG-Board
F1 and F2 cables release