AEG PowerCare LR86CB86 User Manual page 29

You can easily open the door for adding
or removing some items when the icon
is lighted on.
1. Touch the Start / Pause
In the display the related door lock
indicator goes off.
2. Open the appliance door. If
necessary, add or remove the items.
3. Close the door and touch the Start /
Pause button.
The programme or the delay start
continues.
When the icon goes off, the door can
be opened when the programme is
complete, or set spinning or draining
programme/option and than press Start /
Pause button.
11.13 End of the programme
When the programme has finished, the
appliance stops automatically. The
acoustic signals operate (if they are
active).
In the display all washing phase
indicators become steady and the time
area shows .
The indicator of the Start / Pause
button goes off.
The door unlocks and the indicator
goes off.
1. Press the On/Off button to deactivate
the appliance.
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
When you activate the
appliance again, the display
show the end of the last
selected programme. Turn
the programme dial to set a
new cycle.
2. Remove the laundry from the
appliance.
3. Make sure that the drum is empty.
4. Keep the door and the detergent
dispenser slightly ajar to prevent
mildew and odours.
5. Close the water tap.
11.14 Draining water out after
end of cycle
If you have chosen a programme or an
option that does not empty out the water
button.
of the last rinse, the programme is
completed, but:
• The display shows the indicator , the
option indicator
door locked indicator
indicator of the running phase
flashes.
• The drum still turns at regular
intervals to prevent the creases in the
laundry.
• The door stays locked.
• You must drain the water to open the
door:
1. If necessary, touch the Spin button to
decrease the spin speed proposed
by the appliance.
2. Touch the Start / Pause
• If you have set
• If you have set
The option indicator
while the indicator
goes off.
3. When the programme is completed
and the door locked indicator
goes off, you can open the door.
4. Press the On/Off button a few
seconds to deactivate the appliance.
11.15 Stand-by option
The Stand-by function automatically
deactivates the appliance to decrease
the energy consumption when:
• You do not use the appliance for 5
minutes before you touch the Start /
Pause
Press the On/Off button to activate
the appliance again.
or
, the appliance
drains the water and spins.
, the appliance
only drains the water.
or
flashes and then
In any case, the appliance
empties the water out
automatically after
approximately 18 hours.
button.
ENGLISH 29
and the
. The
button:
goes off,