Overview; Windows 95 Installation And Setup - Linksys LNE100TX User Manual

Windows 95 Installation and Setup

Overview

After installing the EtherFast hardware in your computer, follow these instruc-
tions for installing the network device driver. For troubleshooting tips during
setup, refer to the Troubleshooting section.
There are different versions of Windows 95:
• Version A
• Version B (also known as OSR2)
• Version C (with USB support)
The installation procedure for the network driver will vary slightly depending
on which version of Windows 95 you are using. To begin the driver installation,
and to determine which version of Windows 95 you are using:
1. If you already haven't, start up your PC.
2. Windows 95 will automatically detect the EtherFast Card in your com-
puter. If an Update Device Driver Wizard window (below, or another simi-
lar window) appears, you are using Windows 95 version B. If not, you are
using version A. Skip to the Installing the Drive in Windows 95 Version
A section in the Appendix.
7
Linksys Instant EtherFast Series
®
EtherFast 10/100 LAN Cards
®
3. While the Update Device Driver Wizard window is visible, put the
EtherFast ® 10/100 LAN Card Driver Disk into your floppy drive and
click the Next button.
4. A screen will appear stating that Windows 95 was unable to locate the driv-
er. Click the Other Locations button to enter the driver's location manual-
ly.
5. Type the driver location, A:\WIN95, in the location field on the Select
Other Location Screen. Then, click the OK button.
8