Table of Contents
Advertisement
High Gain 9dBi Omni-Directional Antenna
Chapter 3: Getting to Know the High Gain
Omni-Directional Antenna
This chapter explains the components that come with the 9dBi Omni-Directional Antenna.
The Antenna Port
The Antenna has only one port in the tip closer to the mounting bracket. For installation purposes, it is
Figure 3-1: Antenna Port
important to note that the antenna port has a female N-type connector and should only be connected to the
male cable connector.
Antenna Cable
One six-foot low-loss antenna cable is included with this product and is used to connect the Antenna to the
access point. Note that the two connectors have different polarities and one connector is marked with white tape.
The connector with white tape connects to the access point.
The Lightning Protector (Surge Arrestor)
The Lightning protector is used to protect your 9dBi Omni-Directional Antenna when it is used in an outdoor
Figure 3-2: Antenna Cable
environment. The lightning protector screws into the end of the Antenna. Although it is not required, Linksys
recommends using the lightening protector to help prevent damage to equipment.
Mounting Kit
A kit including U-clamps, nuts, washers, and screws are provided to mount the Antenna.
Figure 3-3: Lightning Protector
Chapter 3: Getting to Know the High Gain Omni-Directional Antenna
7
Advertisement
Table of Contents
