Dell EMC PowerEdge R450 Reference Manual page 17

Table 17. Serial Communication details (continued)
Option
Failsafe Baud Rate
Remote Terminal Type
Redirection After Boot
System Profile Settings
To view the System Profile Settings screen, power on the system, press F2, and click System Setup Main Menu > System
BIOS > System Profile Settings.
Table 18. System Profile Settings details
Option
System Profile
CPU Power Management
Memory Frequency
Turbo Boost
C1E
C States
Memory Patrol Scrub
Memory Refresh Rate
Uncore Frequency
Energy Efficient Policy
Description
setup utility may not always revert this setting to the default setting of
Serial Device 1.
Specifies the failsafe baud rate for console redirection. The BIOS attempts to
determine the baud rate automatically. This failsafe baud rate is used only if
the attempt fails, and the value must not be changed. This option is set to
115200 by default.
Sets the remote console terminal type. This option is set to VT100/VT220 by
default.
Enables or disables the BIOS console redirection when the operating system is
loaded. This option is set to Enabled by default.
Description
Sets the system profile. If you set the System Profile option to a mode other than Custom,
the BIOS automatically sets the rest of the options. You can only change the rest of
the options if the mode is set to Custom. This option is set to Performance Per Watt
(DAPC) by default. Other options include Performance, Performance Per Watt (OS) and
Custom.
NOTE: All the parameters on the system profile setting screen are available only when
the System Profile option is set to Custom.
Sets the CPU power management. This option is set to System DBPM (DAPC) by default.
Other option includes Maximum Performance, OS DBPM.
Sets the speed of the system memory. You can select Maximum Performance, Maximum
Reliability or a specific speed. This option is set to Maximum Performance by default.
Enables or disables the processor to operate in the turbo boost mode. This option is set to
Enabled by default.
Enables or disables the processor to switch to a minimum performance state when it is idle.
This option is set to Enabled by default.
Enables or disables the processor to operate in all available power states. C States allow the
processor to enter lower power states when idle. When set to Enabled (OS controlled) or
when set to Autonomous (if hardware controlled is supported), the processor can operate
in all available Power States to save power, but may increase memory latency and frequency
jitter. This option is set to Enabled by default.
Sets the memory patrol scrub mode. This option is set to Standard by default.
Sets the memory refresh rate to either 1x or 2x. This option is set to 1x by default.
Enables you to select the Uncore Frequency option. Dynamic mode enables the processor
to optimize power resources across cores and uncores during runtime. The optimization of
the uncore frequency to either save power or optimize performance is influenced by the
setting of the Energy Efficiency Policy option.
Enables you to select the Energy Efficient Policy option. The CPU uses the setting to
manipulate the internal behavior of the processor and determines whether to target higher
performance or better power savings. This option is set to Balanced Performance by
default.
Pre-operating system management applications 17