34
www.electrolux.com
9. Re-insert the cover (C) on the
opposite side.
10. Place the door on the lower hinge.
11. Take out the cable form the door end
cap cover and place it into the upper
hinge.
12. Re- screw the hinge.
13. Connect the cable to the connecting
point in the front panel.
14. Put back the top front covers on both
sides (2).
15. Place the display cable, which is
currently disconnected, into the cable
holder in the door end cap then put
back the door end cap cover.
A
B
E
F
C
D
1
2
16. Remove the door handle covers (B).
Remove the cover pins (A).
C
C
17. Unscrew the handles (C) and fix them
on the opposite side.
18. Re-insert the cover pins (A) on the
opposite side.
Do a final check to make sure
that:
• All screws are tightened.
• The magnetic seal
adheres to the cabinet.
• The door opens and
closes correctly.
If the ambient temperature is
cold (i.e. in Winter), the
gasket may not fit perfectly to
the cabinet. In that case, wait
for the natural fitting of the
gasket.
In case you do not want to
carry out the above
mentioned operations,
contact the nearest
Authorised Service Centre.
The Authorised Service
specialist will carry out the
reversibility of the doors at
your cost.
B
A
B
A