Table of Contents
Advertisement
■
Do not expose the product to rain. Water entering
the product will increase the risk of electric shock or
malfunction.
■
For best results, your battery tool should be charged
in a location where the temperature is more than 10°C
(50°F) but less than 38°C (100°F). Do not store outside
or in vehicles.
■
Under extreme usage or temperature conditions,
battery leakage may occur. If liquid comes in contact
with your skin, wash immediately with soap and water.
If liquid gets into your eyes, flush them with clean water
for at least 10 minutes, then seek immediate medical
attention.
■
Exhausted batteries are to be removed from the
appliance and safely disposed of.
■
Remove the battery pack when storing the product not
to be used for a long period.
■
The supply terminals are not to be short-circuited.
■
Ensure that the product is switched off and disconnected
from the supply mains / battery pack before removing
the guard.
■
Keep the product dry, clean and free from oil and
grease. Always use a clean cloth when cleaning.
■
When using the product outdoors, the manufacturer
recommends the use of an RCD device with a trip set
at 30 mA.
■
Save these instructions. Refer to them frequently and
use them to instruct others who may use this tool. If you
loan someone this tool, loan them these instructions
also to prevent misuse of the product and possible
injury.
■
Ambient temperature range for tool during operation is
between 0°C and 40°C.
■
Ambient temperature range for tool storage is between
0°C and 40°C.
■
The recommended ambient temperature range for the
charging system during charging is between 10°C and
38°C.
AddItIOnAL BAtteRY sAFetY WARnInGs
■
To reduce the risk of fire, personal injury, and product
damage due to a short circuit, never immerse your
battery pack or charger in fluid or allow a fluid to flow
inside them. Corrosive or conductive fluids, such as
seawater, certain industrial chemicals, and bleach or
bleach-containing products, etc., can cause a short
circuit.
■
Ambient temperature range for battery during use is
between 0°C and 40°C.
■
Ambient temperature range for battery storage is
between 0°C and 20°C.
tRAnsPORtInG LItHIuM BAtteRIes
Transport the battery in accordance with local and national
provisions and regulations.
Follow all special requirements on packaging and labelling
when transporting batteries by a third party. Ensure that
no batteries can come in contact with other batteries or
conductive materials while in transport by protecting exposed
connectors with insulating, non-conductive caps or tape. Do
not transport batteries that are cracked or leaking. Check with
the forwarding company for further advice.
MAIntenAnCe
■
The product should never be connected to a power
supply when assembling parts, making adjustments,
cleaning, performing maintenance, or when the product
is not in use. Disconnecting the product from the power
supply will prevent accidental starting that could cause
serious injury.
■
When servicing, use only original manufacturer's
replacement parts, accessories and attachments.
Use of any other parts may create a hazard or cause
product damage.
■
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury.
■
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types
of commercial solvents and can be damaged by their
use. Use dry cloths to remove dirt, dust, oil, grease, etc.
■
For greater safety and reliability, all repairs should be
performed by an authorised service centre.
LuBRICAtIOn
All of the bearings in the product are lubricated with a
sufficient amount of high grade lubricant for the life span of
the product under normal operating conditions. Therefore,
no further lubrication is required.
envIROnMentAL PROteCtIOn
Recycle raw materials instead of disposing
of as waste. The machine, accessories
and
packaging
environmental-friendly recycling.
sYMBOLs
Safety alert
v
Volts
Direct current
t
The product can be used in a tropical
climate.
Regulatory Compliance Mark (RCM).
Product meets applicable regulatory
requirements.
Please read the instructions carefully
before starting the machine.
Class II, double insulated
should
be
sorted
for
3
Advertisement
Table of Contents
