Advertisement
Quick Links
Advertisement
Related Manuals for NCR 5968-K154
Summary of Contents for NCR 5968-K154
- Page 1 Kit Instructions Capacitive Biometric Reader 5968-K154 Issue A...
-
Page 2: Revision Record
NCR, therefore, reserves the right to change specifications without prior notice. All features, functions, and operations described herein may not be marketed by NCR in all parts of the world. In some instances, photographs are of equipment prototypes. Therefore, before using this document, consult with your NCR representative or NCR office for information that is applicable and current. -
Page 3: Kit Contents
Capacitive Biometric Reader This kit provides a Capacitive Biometric Reader for the 15" or 18.5" 5968 RealPOS X- Series Display. Kit Contents... -
Page 4: Installation Procedure
Capacitive Biometric Reader Installation Procedure 1. Remove the screws (2) that secure the Stand and Rear Cover to the display. Caution: Always use a soft material (cloth, foam) to protect the display screen when placing the terminal face down. 2. Pivot the Stand and Rear Cover assembly as shown to remove it. - Page 5 Capacitive Biometric Reader 3. Remove the Display Collar (7 screws). 4. Remove the Blank Plate from Port A of the Display Collar. The plate is connected to the Display Collar with a strong adhesive. Use care when removing it to avoid damage to the Display Collar.
- Page 6 Capacitive Biometric Reader 5. Mount the Capacitive Biometric Reader on the Display Collar. a. Route the Capacitive Biometric Reader Cable through the cable access of the Display Collar. b. Install the Capacitive Biometric Reader on the Display Collar (2 screws included in the kit).
- Page 7 Capacitive Biometric Reader 7. Install the Display Collar on the terminal (7 screws). 8. Connect the Capacitive Biometric Reader Cable to the Motherboard. 9. Tape the Capacitive Biometric Reader Cable to the Display Sled between the score lines as shown below. This locates the cable so it does not get pinched when the Rear Cover is installed.
- Page 8 Capacitive Biometric Reader Cleaning and Using the Biometrics Reader Sensor Cleaning Procedures Daily Cleaning Before each authentication, it is recommended that the user first clean the sensor. Place adhesive tape onto the sensor and then pull it off. This assures that residue from previous usage is removed.
-
Page 9: Software Drivers
Capacitive Biometric Reader Software Drivers The RealPOS Capacitive Biometrics Reader is a TouchChip TCET Silicon Module utilizing sensor TCETD1FG022. Please visit the Crossmatch website for drivers and application developer tools. https://www.crossmatch.com/company/support/request/...