Table of Contents
Advertisement
www.ti.com
A.1 End User Manual
The OEM integrator must be aware not to provide information to the end user regarding how to install or remove
this RF module in the user's manual of the end product which integrates this module. The end user manual must
include all required regulatory information and warnings as shown in this manual.
A.2 RF Function and Frequency Range
The CC3235MODSM2MOB, CC3235MODSF12MOB, CC3235MODASM2MON, and CC3235MODASF12MON
devices are designed to operate in the WLAN 2.4-GHz and 5-GHz band. The CC3235MODSM2MOB,
CC3235MODSF12MOB, CC3235MODASM2MON, and CC3235MODASF12MON devices support the following
channels dependent on the region of operation:
•
FCC and IC: Ch 1 to 11 (2142 MHz to 2462 MHz) and 36 to 161 (5180 MHz to 5805 MHz)
•
EU: Channels 1 through 13 (2142 MHz to 2472 MHz) and 36 to 136 (5180 MHz to 5680 MHz)
•
JP: Channels 1 through 13 (2142 MHz to 2472 MHz) and 36 to 136 (5180 MHz to 5680 MHz)
Note that the CC3235MODx and CC3235MODAx devices do not support determination of its region through any
external mechanism. The region is set by the application SW, or at the time of programming of the device. The
end user is unable to change the region of operation at any time.
The maximum RF power transmitted in each WLAN 2.4 GHz band is 19 dBm (EIRP power).
The maximum RF power transmitted in each WLAN 5 GHz band is 18.8 dBm (EIRP power).
A.3 FCC and IC Certification and Statement
This device is intended for OEM integrators under the following conditions:
•
The antenna must be installed so 20 cm of space is maintained between the antenna and the users.
•
The transmitter module may not be collocated with any other transmitter of antenna.
•
To comply with FCC and IC regulations limiting maximum RF output power and human exposure to RF
radiation, the maximum antenna gain including cable loss in a mobile exposure condition must not exceed:
– +2.5 dBi in WLAN 2.4 GHz
– +4.5 dBi in WLAN 5 GHz
In the event that these conditions cannot be met (for example, certain laptop configurations or collocation with
another transmitter), then the FCC and IC authorization is no longer considered valid and the FCC and IC
ID cannot be used on the final product. In these circumstances, the OEM integrator will be responsible for
re-evaluating the end product (including the transmitter) and obtaining a separate FCC and IC authorization.
A.3.1 FCC
The TI CC3235MODx and CC3235MODAx modules are certified for FCC as a single-modular transmitter. The
module is an FCC-certified radio module that carries a modular grant.
You are cautioned that changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules.
SWRU548C – FEBRUARY 2019 – REVISED SEPTEMBER 2021
Submit Document Feedback
Manual Information to the End User
Note
CC3235MODSF SimpleLink™ Wi-Fi
Copyright © 2021 Texas Instruments Incorporated
Manual Information to the End User
Appendix A
®
and IoT Solution With MCU
LaunchPad™ Hardware
57
Advertisement
Table of Contents
