Cobra Marine MR HH400X VP Owner's Manual page 24

60
75
Main Icons
Advanced Operation
Operating Your Radio
Intro Operation Customer
Assistance
Memory Location Scan
Main Icons
Memory Location Scan
Intro Operation Customer
During Memory Location Scan, the radio will rapidly switch
Assistance
68
69
from memory location to memory location. Whenever any
activity is detected, the radio will stop the scan for ten (10)
Customer
Installation
71
Assistance
79
seconds to allow you to listen briefly on that memory
A
Customer
Installation
Intro Operation Customer
Assistance
location. It will then continue to scan unless you switch
Secondary Icons Assistance
72
78 Secondary Icons out of the Scan mode.
A
NOTE
Customer
Installation
Assistance
The radio must be squelched for the memory location
Notice Caution
Notice Caution
scan to function. See page 31 for squelch procedure.
Secondary Icons
NOTE
If there are fewer than two (2) memory locations
Notice Caution
programmed in the radio, the memory location
scan option will not be available. To program at
least two (2) memory locations, see page 40.
42 English
Warranty
Warranty
Warranty
Warning
Warning
Warning
Advanced Operation
Operating Your Radio
Intro Operation Customer
Assistance
To Enter Memory Location Scan:
Memory Button
1. From Standby mode, press the Memory button.
2. Press the Scan button.
Customer
The radio will immediately begin to scan the channels you
Installation
Assistance
programmed into the memory. The Scan and Memory icons
Secondary Icons
Scan Button
will show on the LCD.
To Exit Memory Location Scan:
1. From Memory Location Scan mode, press the Scan
button. This will return the radio to Memory mode on the
Notice Caution
last scanned memory location.
Memory Scan Mode
2. Press the Memory button to return to Standby mode on
the last channel shown before entering memory scan.
During Memory Location Scan (while receiving
an incoming transmission), You Can Choose From
The Following:
a. Press the Talk button to remain on that memory location
and end scanning. This will return the radio to Standby
mode.
b. Press the Channel Up or Channel Down button to
resume scanning memory locations.
If you do not press any buttons within ten (10) seconds,
Talk or Channel Up/Down
your radio will automatically resume scanning memory
locations.
During Memory Location Scan (while not receiving a
transmission), You Can Choose From The Following:
a. Press the Talk button to communicate on the last
a memory location scanned and return to Standby mode.
b
b. Press the Channel Up or Channel Down button to change
scan direction.
Warranty
Warning
Nothing comes close to a Cobra ®
43