Husqvarna TC 242TX Operator's Manual page 15

2. Loosen the seat adjustment knob (B).
A
3. Move the seat until it is in a position where you can
push the brake and clutch pedals down.
4. Line up the hole in the seat plate for seat adjustment
knob (A) with the hole in the seat.
5. Install and tighten the seat adjustment knob (A).
6. Tighten the seat adjustment knob (B).
To connect the battery
WARNING:
Make sure that ignition switch is in the OFF
position and that the ignition key is removed.
The cable connections are on the plate on the right side
of the product, above the rear wheel.
1923 - 005 - 13.10.2022
B
Risk of electrical shock.
1. Make sure that the red cable (A) is tightly installed to
the starter solenoid.
B
C
2. Make sure that the protective sleeve (B) does not
touch the terminal end (C) on the black cable (D).
3. Use a ½ in (13 mm) wrench or socket to remove the
ground screw (E) and the black cable (F).
H
F
G
4. Retract the protective sleeve (G) from the terminal
end (H).
5. Install the terminal end on the plate with the ground
screw.
6. Tighten the ground screw.
7. Visually examine the black cable to make sure that
no part of the protective sleeve touches the head of
the ground screw.
8. If it is necessary, loosen the ground screw and
retract the protective sleeve and tighten the ground
screw again.
To move the product off the skid
1. Lift the cutting deck to its highest position. Use the
lift lever.
2. Push the clutch/brake pedal down to release the
parking brake.
A
D
E
15