Husqvarna TC 242TX Operator's Manual page 12

5. Push the 2 screws (A) through the fabric (D) and the
frames.
6. Install the 2 nuts.
CAUTION:
11 Nm.
7. Push the front frame into the clips (E) in the front of
the floor of the grass catcher.
8. Push the 4 clevis pins (F) through the frames and
the 2 cross braces (G).
H
F
H
G
9. Install the 2 retainer springs (H).
10. Push the grass catcher handle (I) through the hole in
the top of the grass catcher.
K
J
11. Install the clevis pin (J) and the clip (K).
To install the grass catcher brackets
1. Install the grass catcher bracket (A) and tighten the
2 screws and the 2 nuts (B). Make sure that the top
edges of the brackets (C) align.
A
12
Use a maximum torqe of
F
I
C
B
2. Install the offset strut (D) and the 4 carrage bolts (E).
E
3. Install the 2 pivots (F).
F
H
4. Install the 2 washer head bolts (G).
5. Install the 4 nuts (H).
To adjust the grass catcher brackets
The position of the grass catcher brackets can be
adjusted.
1. Do the steps that follow to adjust the vertical position
of the grass catcher brackets.
a) Loosen the 4 nuts.
b) Move the brackets to the correct position.
c) Tighten the 4 nuts fully.
E
D
G
1923 - 005 - 13.10.2022