Table of Contents
Advertisement
Safely transporting children in the vehicle
78
Vehicles with reclining rear seats: tilt the back-
#
rest of the reclining rear seat back slightly
before the ISOFIX child restraint system is
installed.
Fold upholstered lining
1
upwards.
#
Pull the tab on upholstered lining
#
and position it on the support surface.
Upholstered lining
1
will remain folded
upwards.
Attach the ISOFIX child restraint system to
#
both mounting brackets
2
in the vehicle.
1
To close, fold upholstered lining
#
Lift the tab from the support surface and slide
#
it back into the upholstery slot between the
seat backrest and seat cushion. Close the
upholstery flap.
Vehicles with reclining rear seats: return the
#
reclining rear seat backrest to an upright posi-
tion.
The reclining rear seat backrest must be in
contact with the child restraint system.
Fastening a Top Tether
& WARNING Risk of injury or death from
adjusting the seat after installing a child
restraint system
Vehicles with electrically adjustable rear
1
upwards
bench seats:
The following may occur:
The Top Tether belt may sit either too loose
R
or too tight
The child restraint system may be loose,
R
upwards.
incorrectly positioned or damaged and
then not perform its intended protective
function.
Never adjust the seat after the child
#
restraint system has been installed.
¯ If the child restraint system is equipped
with a Top Tether belt:
The risk of injury may be reduced by Top
Tether. The Top Tether belt enables an
additional connection between the child
restraint system attached with LATCH-type
(ISOFIX) (left and right rear seats) or the
seat belt (all rear seats) and the vehicle.
%
Canada: Only the two outer Top Tether ancho-
rages are available.
If necessary, slide head restraint
#
(
page 127).
/
Remove cover
2
of Top Tether anchorage
#
3.
1
upwards
Advertisement
Table of Contents
