Cobra PI2000 Operating Instructions Manual page 6

Connection
Connection 2. Connect both sets of cables to the power input
terminals on right side panel of the inverter.
continued
The red terminals are positive (+) and the
CAUTION: Loosely tightened
black terminals are negative (-). Insert the bare
connectors can cause exces-
ends of the cables into the terminals and
sive voltage drops and may
tighten the screws to clamp the wires safely.
result in overheated wires and
melted insulation.
CAUTION: A reverse polarity
connection (positive to nega-
tive) will blow the fuse in the
inverter and may permanently
3. Connect each cable from the negative (black)
damage the unit.
terminal of inverter to the negative terminal of
the power source. Make a secure connection.
CAUTION: Remove any jewel-
All power connections to your Cobra inverter
ry (watch, ring etc.). Be careful
must be positive to positive and negative to
not to short circuit the battery
negative.
with any metallic object
(wrench, etc.).
4. Connect the cables from the positive (red) ter-
minals of the inverter to the positive terminal of
NOTE: If only one power
the power source. Make a secure connection.
source is used, connect both
cables from the negative ter-
minal of the inverter to the
negative terminal of the power
source. Then connect both
cables from the positive termi-
nals of the inverter to the posi-
tive terminal of the power
source.
6
5. If a DC power supply is being used as the
power source, switch it On. Turn the ON/OFF
switch on the inverter to the On position.
Check the meters on the left side panel. The
voltage should indicate between 11 and 14
volts, depending on the voltage of the power
source.
6. Turn the inverter's ON/OFF switch to the Off
position. The indicator lights may blink and
the internal alarm may sound momentarily.
This is normal. Plug the test load into the AC
receptacle on the left side panel of the invert-
er. Leave the test load switched Off.
7. Switch the inverter's ON/OFF switch to the On
position and turn the test load On. The inverter
should supply power to the load.
If it does not, please consult the troubleshoot-
ing section in this manual.
Connection
Connection
continued
WARNING: You may observe a
spark when making the con-
nection because current can
flow to charge the capacitors
in the inverter. Do not make
this connection in the pres-
ence of flammable fumes.
Explosion or fire may result.
7