Replacing The Handset Battery; Handset Battery Disposal; Cleaning The Charging Contacts - Cobra Intenna CP-2525 Operating Instructions Manual

Cordless telephone with caller id
Table of Contents

Advertisement

REPLACING THE HANDSET BATTERY

The rechargeable NiCad battery in your cordless phone may need to be replaced
if the handset will not function when the TALK button is pressed after recharging
for 12 hours.
Replacement batteries are available direct from Cobra (see accessories order form
at the end of this booklet or call 1-773-889-3087).
1.
To remove the battery door, press
and slide downward.
2.
Carefully disconnect the battery
pack and dispose of it properly.
See BATTERY DISPOSAL below.
3.
To replace, observe connection
orientation and connect the new
battery and replace the door.
Return the handset to the base
and charge the battery overnight
(at least 12 hours).

HANDSET BATTERY DISPOSAL

The rechargeable nickel cadmium (NiCad) battery in this product must be
recycled or disposed of properly in compliance with all applicable laws. It may
not be thrown in the trash. Certain states or municipalities require recycling and
have established collection programs. Please contact your local waste removal
authority for instructions, or return to Cobra for recycling. Wrap batteries
carefully and mail postage prepaid to: Cobra Electronics Corporation, 6500 W.
Cortland Street, Chicago, Illinois 60707, Attn: Battery Recycling.
Or contact the Rechargeable
at 1-800-8BATTERY for a local recycling center near you. For more information
about battery recycling, the RBRC has a web site at:
http://www.RBRC.com
DO NOT PUT BATTERIES INTO
FIRE OR EXPOSE TO HIGH HEAT.
THEY MAY EXPLODE.

CLEANING THE CHARGING CONTACTS

Clean the two metal charging contacts on the base and handset with a soft dry
cloth on a regular basis to ensure optimum performance of the battery-charging
system. Rubbing alcohol may be used if more thorough cleaning is required.
Battery
Recycling
Corporation
19
About Cordless Phone Performance
Your Cobra Intenna cordless phone uses radio transmission to communicate
between the base and handset. It is thus subject to occasional interferenceÑstatic
or buzzing noises, for example. These conditions may be caused by electrical
motors on household appliances, ßuorescent lights, electrical storms and other
sources.
These steps will enhance the maximum performance of your new phone:
• Change channels by pressing the CHANNEL button on the handset if you
experience interference.
• Don't cover the upper section of the cordless handset with your hand (see
diagram below). This may block the internal antenna located at the top of
the handset, possibly reducing the phoneÕs range and audio clarity. Always
hold the handset at the middle or close to the bottom
INCORRECT
• Avoid resting the handset on your shoulder during conversations; this may
also block the performance of the internal antenna.
• Avoid plugging your phone's power cord into an active AC outlet that also
provides power for a major appliance or for charging units a for cordless
(RBRC)
appliances (vacuums, screwdrivers, etc.) or other electronic devices.
Hold the cordless
handset at the middle
or bottom area of your
phone for best
performance and range.
CORRECT
20

Advertisement

Table of Contents
loading

Table of Contents